Fasten the paper down to the board or frame with masking tape or with binder clips. Now, staple with staples about 2 inches apart.
Impressionist Painting Back Face Mask High Quality
First you soak the pape r, then you stretch it.
How to stretch watercolor paper with masking tape. This kind of tape is water activated. (if it helps, you can use a few small pieces of tape to hold the paper in place as you tape your first edge.) that’s it! Get your paper lined up straight on your board, and tape each side.
The heaviest paper (300 lb) may not need to be stretched; Gently run your fingers around the edge to make sure all the air bubbles are removed but trying not to stretch the tape. She is using arches 140lb cold pressed bright white paper.
Get your paper lined up straight on your board, and tape each side. The paper will need to be wetted repeatedly and turned over to ensure the entire surface is adequately soaked. Be careful not to drip glue from the gummed tape onto your paper, the glue will dry and cause blotchy marks when you paint.
Place along all four outer edges of the paper, covering just about ¼” of the paper. You can do it with masking tape and be ready to paint 15 minutes! Now wet the paper using clear water and a large soft brush.
Stretching paper using this method can take considerably longer. You now have stapled one of the two short lengths of your paper. After a lot of experimenting with different techniques, however, i finally settled on using blue painter’s tape (like this stuff) to stretch my paper.
Let the sheet dry overnight. Can i use masking tape to stretch watercolor paper? Next, the second staple goes in the corner that is closest to the first staple.
How do you tape watercolor paper mounting or taping watercolor paper is a breeze if you have your scissors, a ruler, and tape with you. Tape your paper down to a board and use masking tape to fix the paper in place. If the paper is too wet, blot it with a clean sponge and if the tape is too dry, simply run a damp sponge over it.
You can also dampen the paper with a sponge and spray bottle on a clean board. Staple one corner of the paper to the board. Finally dry the paper using a hairdryer !
It works really well for relatively small pieces. Your tape should not be dripping. Allow 1″ for gummed paper tape all the way round your paper when cutting to size.
Proceed to stretch the paper to your liking. This video shows my preferred method, stretching on the same stretcher bars used for canvas, and an alternate method for those who have difficulty. Gummed tape will stretch with the paper but masking tape will not.
Place the tape along all four edges of the paper, covering about a quarter of an inch. The knack to a successful 'stretch' is to ensure that the paper and the gummed tape are of a similar wetness and, so, will dry at the same rate. Stretching your watercolour doesn't have to be messy or difficult.
(if it helps, you can use a few small pieces of tape to hold the paper in place as you tape your first edge.) Make sure there’s no air trapped under the paper. Create your painting while the sheet is still taped to the board.
Remove your paper from the water bath by holding one corner and allow any excess water to drain from the opposite corner. Tape the sheet to the board using gummed paper tape or masking tape. To fix the soaked paper you need some gummed tape.
Remember to apply a little water to the adhesive of the paper but not too much as that can ruin the glue. Now repeat the other short side. Lay it on your board and dry the top surface of the paper completely with a paper towel.
It depends on the amount of water you anticipate using in your painting. Try to leave the paper in a warm dry place to dry overnight or if you are in a hurry leave it some minutes. Tilt your paper to see if there are any dry spots and correct those.
Once your paper is the correct size, mounting it just takes 4 pieces of masking tape. After measuring the paper dimensions, straighten the piece and start cutting the tape to cover around 0.25 to 0.5 inches of the paper edges. Fill a large sink or bath with water and submerge the paper, rolling or folding it as necessary, but avoiding creasing it.
Using masking tape as a mask for watercolor is done by laying down a strip of masking tape over your shape on your watercolor paper and then carefully cutting around it to protect that shape. Mounting the watercolor paper once your paper is the correct size, mounting it just takes 4 pieces of masking tape. You’ll have to flip the paper a few times to adequately saturate the paper enough to stretch it.
Go over the paper a couple of times to make sure the whole surface is dampened. Let the paper dry overnight. Whichever method you choose to stretch your paper, the basic approach is the same:
Lay the wet paper on a clean board and gently smooth the paper with a clean sponge and remove any excess water. Paper can be stretched up to a size of approximately 1.5m x 2.5m but if you go beyond that, the tension in the paper will be too strong. Then, holding the tape evenly over the whole length lower the tape strip all at once to the edge of the paper, half on the paper and half on the board.
Masking tape works best on watercolor paper, less so on the canvas, yupo, and clay board surfaces because the paint can seep under the tape if it is not sealed well. How to stretch your watercolor paper: Once the paper is dry, it will be stretched tight on the board and will not warp when watercolor is added.
Pin von Erfan Rahimi auf Plastik Plastik
Stretching portrait silhouettes Haunted mansion